35
SERVICE AND MAINTENANCE
Wear condition of the brake
Wear condition of brake pads varies according to the use of the
vehicle, riding style and road conditions. Generally speaking, the brake
pads may wear faster when driving on wet and dirty roads. Brake pad
wear should be checked at every scheduled maintenance.
In a hydraulic brake system, the thickness of brake disk and brake
pad must be checked. Check the wear mark
(1)
on each
brake pad, if
one of the two brake pads is worn to the wear mark, replace both
pads.
If the thickness of brake disk is worn to its limit (less than
3mm), the disk must be replaced at once.
Battery
This model uses a 12V-7Ah lead-acid battery. The battery will be prepared for use before you take delivery
of the motorcycle.
Please note the following:
1. If the motorcycle is stored for a long time, the battery must be removed and charged fully, then stored
in a cool dry place. If the battery is left on the vehicle, remove the negative cable from the battery pole.
2.
When removing the battery, the ignition switch should be in “
” position and the negative cable
removed. When installing, connect the positive cable first, then the negative one.
1: Wear mark
