35
SERVICE AND MAINTENANCE
1. If the motorcycle is stored for a long time, the battery must be removed and charged fully, then
stored in a cool dry place. If the battery is left on the vehicle, remove the negative cable from the
battery pole.
2. When removing the battery, the ignition switch should be in “
” position and the negative cable
removed. When installing, connect the positive cable first, then the negative one.
3. Battery poles erode easily. Brush them clean with a needle brush then apply a film of Vaseline or
grease.
4. When installing the battery, terminal bolts must be screwed tightly.
Battery removal
1. Remove the cover screw and open the battery case cover.
2. Disconnect the negative cable from the battery first, then the positive cable.
3. Take the battery out of the battery case.
!
WARNING:
- The battery may produce explosive gas. Keep away from any spark or flame.
- The battery contains acid. Avoid contact with the skin or eyes. Keep away from children.
!
ATTENTION:
- When starting the engine, do not use the starter motor for more than 5 seconds at a time. Alternatively, the
kick-starter can be used.
- When the battery requires recharging, use 0.7A charging current and 12.5V charging voltage.
