EN-15
To perform a β-Ketone control solution test, do the following:
1. Insert the β-Ketone test strip into the test slot of the
device. Wait for the device to display the test strip “
“ and blood drop “ “.
2. Apply the 4SURE β-Ketone control solution. Shake the control solution vial
thoroughly before use. Squeeze out a drop and wipe it off, then squeeze another
drop and place it on the top of the vial cap. Hold the device to move the absorbent
hole of the test strip to touch the drop. Once the confirmation window is filled
completely, the device will begin counting down.
Note:
To avoid contaminating the control solution, do not directly apply the control solution
onto a strip.
3. Read and compare the result. After counting down to
0, the test result of the control solution will appear on
the display. Compare this result with the range printed
on the individual foil pack and it should fall within
this range. If the test result is out of range, read the
instructions again and repeat the control solution test.
2.0~3.3
623
mmol/L
4. The meter will detect the difference between control solution and blood samples
automatically. It will automatically marks the result as a control solution test with
“
” display.
Note:
• Control solution test results are stored in the memory.
• The control solution range printed on the individual foil pack is for control solution
use only. It is not a recommended range for your blood glucose level.
• Refer to the Maintenance section for important information about your control
solutions.
Summary of Contents for 4Sure Smart Duo
