www.nitedevil.com
XSEE240
NiteDevil Traditional Wide Dynamic HD Cameras
Multi-Format (TVI/AHD/CVI/CVBS)
Last Revised: 12/04/2018
Connecting the camera to other equipment
This traditional camera comes with a BNC for video and a 2 pin adapter for power. A short power
lead (approx. 16cm long) is supplied that connects to a psu with a 2.1 power jack and terminal
connections at other end, for connecting to terminal connector on back of camera. Ensure that cables
are connected with the correct polarity if using the 12vDC model SEE240. The SEE243
12vDC/24vAC model is not polarity sensitive.
Accessing the Camera Menu
The camera video format can be selected from TVI/AHD/CVI/CVBS. CVBS is the analogue
format. Connect the HD camera to control equipment using a female BNC-BNC lead. When using
a co-ax type cable such as RG59 or similar, the outer braid of the co-ax provides the “0V
GROUND” connection and the inner core provides the “Video” connection.
When you are in correct format, press the joystick button in, momentarily, if you wish to access the
menu.
First power the camera up when it is connected to a monitor or DVR and
monitor, and see if the required format displays a colour picture.
If not, press the joystick enter button for 3 seconds. The joystick is
accessed by sliding the side cover back next to the 4 pin lens connection.
The enter button is shown here
Repeat until picture displays in colour and is sharp.
(Note that picture may be in b/w in low light levels or the cellophane lens
cover has not been removed).
Alternatively if you use the menu, you can change the camera format in
the menu:
Example - Change camera format to TVI:
<System> <Output> <MAIN OUTPUT ANALOG OUT0
<System> <Output> <ANALOG OUT0 TVI
TVI
AHD
TVI
CVI
CVBS
The above shows format cycle
