3
NL50_NL100 Man.Ver 1.0_2_2018
FIGURE 5
FIGURE 4
Wire Channel
Thumb Wheel
FIGURE 6
INSTALLING THE LIGHT
1. Ensure the wire from the light is connected to the power supply as in the TEST LIGHT FUNCTION section
(Fig 1 and 2).
2. Walk the light to the location where it will be installed and ensure there is enough wire to reach that location
and the outlet without putting stress on the cable, light or power supply.
3. Remove the top cap of the pool’s vertical post nearest to the point of installation.
4. Lift one side of the pool’s top ledge - screws may have to be removed (Fig 4).
5. Slide the light onto the pool wall so that the light is centered in the middle of the top ledge.
6. Hold the light so the mounting bracket is flush with the top of the pool wall and turn the Thumb Wheel in a
clockwise direction to secure the light to the wall (Fig 5).
7. Be sure the wire runs through the Wire Channel of the Mounting Bracket.
8. Reinstall the top ledge and cap.
9. Ensure the water level is above the minimum water line on the light which is indicated by the first row of dots
above the light housing - add water if needed (Fig 6).
10. Mount the transformer to a vertical surface that is at least 18 inches from the ground using the provided screw.
OPERATING THE LIGHT
1. Ensure the connection between the light cord and power supply is secure.
2. Ensure the water level is above the minimum water line on the light which is indicated by the first row of dots
above the light housing - add water if needed (Fig 6).
3. Plug the 3 pronged cord into a GFCI outlet.
4. Press and release the button on the power supply (Fig 3) - the light will illuminate.
5. The light will turn off automatically in 2 hours or the button on the power supply can be pressed to turn the
light off manually.
WINTERIZATION
IMPORTANT:
Failure to winterize the light and power supply properly may damage the product and will void the
product warranty.
1. Unplug the power supply from the outlet.
2. Disconnect the cable from the light to the power supply.
3. Remove the light from the pool by following steps 3-8 in the installation with the exception of removing the
light instead of installing the light.
4. Store the light and power supply in an area that will remain above 50°F.
