NiteRider Digital HeadTrip, User Manual

6

M O U N T I N G   T H E   H E A D L A M P

The Digital HeadTrip headlamp is conveniently mounted to

your helmet.

Helmet Mount

1. Unclamp the straps on each

side of the helmet mount and

pull them free.

2. Position the plastic mounting

plate as close to the centerline

of the helmet as possible,

orienting the parallel grooves on

the slider clip to the rear.

3. Feed each strap into and out of

two helmet vents, circling each

strap back to the upper edge of

the corresponding clamp.

4. Fasten the straps by inserting them into the clamps. 

Inserting the Headlamp into 

the Helmet Mount

Insert the headlamp mount into

the helmet mount slider clip from

the rear of the slider clip forward.

Gently rocking the lamp as you

slide it may help. Do not push the

release lever when inserting the

headlamp into the slider clip; let

the lamp snap into place by itself. 

To remove the headlamp, push the release lever and slide the

lamp backward. 

Note

: After mounting the headlamp, adjust the headlamp so

it illuminates the road properly without distracting oncoming

riders.

Headlamp mount with

release lever