NITO N1e, User Manual

Assemble the scooter by following the instructions on the 

next page. The following tools are required for assembly 

and are not included in the package:

cross screwdriver, 8mm wrench and 5 mm allen key

Insert the bottom of the steering column into 
the frame. Tighten the quick release to secure 
the steering column. 

Use the screws provided to attach the display, 
buttons and bell to the handlebar. The diagram 
above shows where to place each item.

Attach the handlebar to the fitting on the 
steering column. Make sure the brake levers 
are facing forward, like in the picture above.

Attach the wooden board to the frame. 
Place the metal bracket provided under the 
elevated part of the frame, and attach it with 
2 screws (provided). Attach the front of the 
wooden board with 2 screws and secure with 
a washer and bolt (provided). Use the diagram 
above for reference.

Adjust the handlebars up to the mark  
that indicates the maximum height.

Do not exceed the maximum height mark.

Recommended tire pressure for an adult rider is 2.7 bar/39 psi.  

If the rider weighs less than 40 kg reduce the tire pressure to  2.2 bar/32 psi

ASSEMBLY INSTRUCTIONS

6

7

N1

e

 - USER M

ANU

AL

NIT

O ELEC

TRIC KICK SCOO

TER