NITO N1e, User Manual

2.9 Display and delete data 

Wait until the scooter has been on for 5 seconds, then hold 

 and 

 buttons at the same time. This will make the 

single trip riding time (

TM

) and single trip distance (

DST

) 

flash. Press 

 button to delete this data.

3. Automatically prompt interface.

3.1 Error Code Display

error code  meaning

01_info 

Throttle issue 

03_info 

Motor hall signal issue 

05_info 

Axis speed sensor issue (only applies to torque sensor) 

06_info 

Motor or controller has short circuit issue

Electronic control system failure will display a (flashing) fault code.

Once the fault has been removed, the fault code display interface will 
automatically be removed. 
 

3.2 Motor temperature alarm

If the motor temperature reaches the warning temperature, the text 

MOTOR

°C 

(

°F

) will flash on the display. If this occurs, shut off the motor 

as soon as possible and wait for the motor temperature to decrease.

2.8 Battery charge indicator

When charge is above 70%, four battery bars (full battery) 
will appear. Bars will reduce as battery charge reduces. 
When charge is below 15%, zero bars will appear. If the motor 
shuts off because of a low battery (0% battery charge), the 
battery indicator will flash. At this point, the scooter should 
be shut down completely and charged. 
Battery indicator automatically identifies 24V, 36V and 48V 
batteries (when supported batteries are being used).

2.7 Brake status display

When using the brakes, the brake status will be displayed.

16

17

N1

e

 - USER M

ANU

AL

NIT

O ELEC

TRIC KICK SCOO

TER