6.
Install the 1/8 poly line into the push-to-connect fitting previously installed in the
nitrous solenoid outlet port and route the line into the air filter. The hose should
discharge toward the air filter but should not be inserted directly into it. Secure the
line with zip ties.
7.
Follow the wiring diagram below, solder and wrap all connections with heat shrink
to complete the install. The nitrous solenoid in this system is DC, so any wire can be
chosen as power or ground wire.
8.
Once all connections are secured, test the system by arming the master arming
switch and activating the throttle servo until wide-open throttle is achieved, the
