Documentation Corrections to the NVM-2 Setup Guide
Issue 1-0
51
Instructions for Installing a 124i, Onyx VS or Businesscom DS01 Phone
System
The instructions (Step 5: Connect NVM-2 to Your Phone System) in the
Setup Guide (P/N 17690SET02) are not correct for installing a 124i,
Onyx VS or Businesscom DS01 phone system. Corrected instructions
are as follows.
Installing a 124i, Onyx VS or Businesscom DS01 Phone
System
NOTE:
An alternate method for installing the 124i is on the following
page.
Read the instructions next to
➍
below and look for
➍
on Figure 2.
Repeat for
➎
.
➍
Plug one
end of a modular line cord into Voice Mail port 1 on the
NVM-2. Plug the other end into an ASI or Dual ASI. Connect the
ASI or Dual ASI to the phone system. (Figure 2 shows connecting
to a Dual ASI.)
➎
Repeat
➍
for Voice mail Port 2 (as well as 3 and 4) if installed.
IMPORTANT NOTE
Extension will receive notification of new messages (blinking
Message Waiting lights and interrupted dial tone for single line
phones) only if Voice Mail port 2 is connected to the Phone
System.
Figure 2 Connecting NVM-2 to a 124i, Onyx VS or Businesscom DSO1 Phone System
Summary of Contents for NVM-2
