Nitto Kohki Baby Belton BB-10A, Instruction Manual

4

INSTRUCTIONS FOR 

THIS TOOL

About Your Tool

Warning

●

 Wear protective glasses and a dustproof mask. 

Operation generates dust and abrasive particles, 

etc. which may cause eye and/or respiratory injury: 

Always use PPE (Personal Protective Equipment) 

for eye and respiratory protection.

●

 When you change or adjust the tool or parts, be 

sure to detach the tool from the air hose.

●

 Never touch the moving parts while in operation.

●

 Do not remove the Protective Cover from the 

tool while sanding.  The Abrasive Belt runs very 

fast.  Without the Protective Cover, your fingers 

and hand may be injured when they touch the 

running belt.

Caution

●

 Protect yourself from dust and abrasive particles.

When sanding hot dust and abrasive particles fly off 

the workpiece: Always wear eye protection glasses, 

long sleeve protective clothing, gloves (except 

knitted gloves), foot and leg protection, etc. to 

protect yourself.  Always keep your face away from 

the sanding surface.

●

 Always use the genuine Abrasive Belt for the 

belt sander BB-10A (Nitto Kohki Co., Ltd.).

1. USAGE

This is a handheld pneumatic belt sander designed 

and built to perform sanding operation utilizing a 

abrasive belt.

2. CHECK THE CONTENTS OF THE PACKAGE

Upon unpacking, check to see that the shipment is 

complete without damage or oil leakage in transport. 

Should you find any damage or short-shipment, 

please contact sales agent through which you have 

purchased your tool or authorized dealer near you for 

corrective actions.   

Package Contents

Qty

Check

BB-10A

1set

Abrasive Belt Z76 #100×10; (on tool)

1

Abrasive Belt Z76 #120×10

1

Abrasive Belt Z76 #180×10

1

Abrasive Belt Z76 #240×10

1

Hex. Socket Screw Key 1.5

1

Bushing R1/4×NPT1/4

1

Instruction Manual

1

Declaration of Conformity

1

Caution for Use

1

3. AIR SUPPLY

3-1. Air Pressure

Adjust air pressure with the Air Regulator to the level 

appropriate for the pneumatic tool used.

Air pressure that is too low fails the Tool to operate at 

full capacity.

Air pressure that is too high may cause damage to the 

Tool.

3-2. Air Line 

(Fig. 1)

Use a 9.5 mm (3/8”) I.D. Connecting Hose between 

the Compressor and the Tool.

Drained water, etc., if flown into the Tool, could 

cause Tool failure.  Install an Air Filter. between the 

Compressor and the Tool.

Air Regulator

Oiler

Air Filter

Compressor

Lubrication

Tool

9.5mm (3/8”) 

I

.D.

Hose

Cupla

Fig. 1

3-3. Lubrication

Install an Oiler between the Compressor and the Tool.  

Use the machine oil ISO VG-10.  Failure to lubricate 

as required may result in damage to the Tool. Use of 

oil that is too thick will reduce the performance of Tool.

4. HOW TO OPERATE THE TOOL

Warning

●

 When sanding, always wear protective glasses 

and respiratory protection: Microscopic dust and 

abrasive particles that fly off the workpiece may 

cause eye or respiratory injury or both.