43
EN
Workpiece
Workpiece detection
sensor
Basic operation
When workpiece is detected, the [WORK] LED lights in green and the electric screwdriver becomes operable.
When workpiece is not detected ([WORK] LED lights off), the electric screwdriver is not operable.
If workpiece is removed before completing a series of screw fastening operations (before the screw count reaches the
set value), NG occurs and an NG signal is output. Set up the workpiece again or insert WORK RESET to cancel the
NG.
If workpiece is removed after completing a series of screw fastening operations (after the screw count reaches the set
value), it becomes operations OK.
Setting related to workpiece signal
If the workpiece signal is used, the settings below are valid.
Setting item
Reference
Workpiece setup time (No.14 WORK-S-T)
p. 31
Screw fastening confirmation time (No.17 OK-OUT-T)
p. 33
OK output timing (No.18 OK-TIMING)
p. 33
OK buzzer sound (No.19 OK-BZ)
p. 33
NG buzzer sound (No.20 NG-BZ)
p. 33
TV07783-1_DLV10C_en.indb 43
2017/06/27 17:41:41
