![background image](http://html.mh-extra.com/html/nitto-seiko/kx-series/kx-series_instruction-manual_1696677008.webp)
KX driver tool unit
6
2. Inspection and Delivery
When you receive a KX driver series product, check and inspect it as follows:
Check/inspection item
Remarks
[1] Is the product what you have ordered?
Check it with the “Model” shown on the labels of the tool unit
and the controller. (Refer to the table in previous clause.)
[2] Does the output shaft of the tool unit rotate
smoothly?
It’s OK if you can rotate it lightly with your hand.
[3] Is there any broken part?
Check for any damage caused during transportation etc. by
viewing its appearance.
[4] Is there any tightened part, such as a screw,
that comes loose?
Make a check with a tool, such as a wrench, as necessary.
If you find any problem mentioned above, contact the agent you have purchased from or our sales office
immediately.
3. Handling precautions
(1) Don’t give a shock to the motor in the tool unit. Otherwise, a failure may occur.
(2) Don’t pull a cable (encoder, motor power supply) of the tool unit. Otherwise, it may be broken. Be
sure to fix the cable when installing the tool unit.
(3) Don’t give a strong shock to or place a load on the output shaft of the tool unit. Otherwise, a failure
may occur.
(Allowable loads are as follows.)
(4) The tool unit is designed to be used indoors. Use it under the following environment.
(The motor section supports IP55 (with some exception))
Indoor environment free from corrosive and explosive gas
Well-ventilated and free from dust and humidity
Ambient temperature range: 0
-
40
°
C
Humidity range: 20-80%RH without condensation
1000m less or equal above sea level.
Environment enabling easy inspection and cleaning
Locations free from strong electric or magnetic field
Locations in which atmosphere is free from conductive powders including iron powder
Locations free from excessive vibration or impact
Radial load
Thrust load
Allowable load (N)
Single load
Axial load: 100 N max.
Radial load: 50 N max.
Combined load
At axial load 80 N
→
Radial load 23 N max.
At axial load 50 N
→
Radial load 43 N max.
Summary of Contents for KX Series
Page 2: ......
Page 30: ... Machinery Division http www nittoseiko co jp ...