5 Installation guide
Body assembly
1. Secure the scooter neck tube and open the kickstand.
2. Connect the handlebar to the main line connector of the vertical tube, and install the handlebar to the vertical tube
.
3. Confirm that the device will power on and off after assembly.
4. Lock the screws on both sides alternately with the hexagon wrench in the packaging box (tightening torque: 4~5N*m), that is, the assembly is completed.
Folding and handling
Folding
Confirm that the kick scooter is powered off, then hold the vertical tube, open the folding wrench, align it to the position of the mudguard hook, and finally hook the
hook under the dashboard to the rear end of the body. Press the buckle button on the mudguard when opening. After the hook under the dashboard is separated from
the folding buckle, straighten the vertical tube to lock the folded plate and then turn the folding wrench back.
Handling
Confirm that the kick scooter is powered off, then hold the vertical tube, open the folding wrench, align it to the position of the mudguard hook, and finally hook the
hook under the dashboard to the rear end of the body. Press the buckle button on the mudguard to open it. After the hook under the dashboard is separated from the
folding buckle, straighten the vertical tube to lock the folded plate and then turn the folding wrench back.
Charger connection
Firstly open the charging port, then plug the charging plug into the body charging port and finally connect the power supply to charge. After the completion of
charging, fastening down the charging port to beware of water intake.
Caution!
Do not charge when the charging port, charger or power socket is wet.
Turn off the power before charging.
The original charger provided by Niu can be only used when charging. Do not use any other type of chargers.
