30
29
No output when
switched on
1. Dead battery
2. Alarm failure
1. Charge the battery.
2. Contact your dealer for
professional checks.
Troubleshooting List
Malfunction
Description
Causes
Troubleshooting
1. Battery level is low
2. The power off switch is enabled
when pulling the brake lever
3. The Parking Mode has not been
turned off yet
1. The plug of the battery not
properly connected with the
battery socket
2. Battery is overdischarged
1. Low battery level
2. Under-inflation of tyres
3. Frequent braking and overload
4. Battery aging or normal capacity
loss
5. Low battery capacity resulting
from low temperature
1. Charge the battery.
2. Check the tyre inflation.
3. Develop good riding habits.
4. Replace the battery.
5. Normal situaiton.
1. Check whether the plug is
loosened.
2. Contact your dealer for
professional checks.
Motor failure when
turning the twist grip
after switched on
Battery charge failure
Dropping speed or
range
1. Charge the battery.
2. Do not pull the brake lever when
twisting the twist grip.
3. Check “Start the Scooter” section
of this Manual.
Identify the fault causes in reference to the Diagnostic Codes on
Dashboard.
Contact your dealer if the troubleshooting methods listed in this manual
is not working.
Dead battery
Charge the battery
Sudden stop during
a ride
Troubleshooting List
Malfunction
Description
Causes
Troubleshooting
00 displayed
10 displayed
11 displayed
12 displayed
13 displayed
20 displayed
1. Disconnect the battery and reconnect it
after 30 seconds.
2. Check whether the wires are loosened.
3. Contact your dealer for professional
checks.
Stop the scooter and restart later.
Stop the scooter and restart later.
Contact your dealer for professional checks.
Disconnect the battery and cool it down
before reuse.
Stop the scooter and restart when cooled
down.
Communication failure or
Dashboard failure
FOC Controller locked rotor
FOC Controller overcurrent
FOC Controller
overtemperature
Motor overtemperature
FOC Controller
undervoltage/overvoltage
Summary of Contents for NQi GTS
Page 1: ...USER MANUAL V 1 0...
