8
Changing the channel in laser level:
• Turn the laser level.
• Hold the X / Y for about 5 seconds. You will see the blinking icons:
antenna and channel number.
• Change the channel number using the + or - on the same as the one set
the remote control.
• Remember, holding the X / Y until turns off the channel number.
• antenna icon continue to blink.
• Then turn off the laser level and turn it on again.
• non-blinking antenna icon indicates a proper connection with the remote
NOTE:
In exceptional cases, you may experience instability working of laser level in cooperation with
the remote control. This is caused by data transmission system between the remote control and
leveling tool. The communication system is based on a radio transmitter operating on UHF. In
this range there are multiple transmission systems and their frequencies can interfere with each
other. In the case of unstable behaviour leveling change the channel on the remote control
communicates with the leveling tool.
