12
ports, then press it until the cover and the chassis are combined tightly.
FIG.9
5. If you are installing power management software, connect your computer to one of the
communication ports or optional connectivity card. For the communication ports, use an appropriate
cable.
6. If your rack has conductors for grounding or bonding of ungrounded metal parts, connect the
ground cable (not supplied) to the ground bonding screw. See “Rear Covers” for the location of the
ground bonding screw for each model.
7. If an emergency power-off (disconnect) switch is required by local codes, see “Remote Emergency
Power-off” (REPO) to install the REPO switch before powering on the UPS.
8. Continue to “UPS Initial Startup”.
Connecting the EBP(s)
To install the optional EBP(s) for a UPS:
1.
Remove the front cover of each EBP and UPS (see FIG. 10).
It is the same with the installation of the front cover. (Refer” To install the UPS “)
FIG.10
Removing the EBP Front Cover
2.
On the bottom of the UPS front cover, remove the EBP cable knockout (see FIG. 11).
