Nivona CafeRomatica NICR7, Operating Instructions Manual

47

remains on power-saving ECO Mode
with minimal heat output 3 minutes
after its last use – therefore using less
electricity. If the coffee maker is star-
ted from power-saving ECO Mode, this
can take a few seconds longer (heat i-
ng time). You can also deactivate the
ECO Mode, so that the appliance is
on full stand-by while switched on:

➔ 

Press the program key 

P

to enter

programming mode.

➔ 

Press the 

>

key until “PROGRAM

ECO-MODE” appears.

➔ 

Press the 

ok

key. The display reads

“ECO-MODE YES”.

➔ 

Press the 

>

key until your desired

ECO Mode setting appears.

➔ 

Press the 

ok

key to confirm.

➔ 

You can now either continue in pro-

gramming mode to change other func-
tion settings or press 

exit

twice to lea-

ve programming mode.

... 4. Programming functions

5.1 Inserting filter

Note: 

See chapter 4.2 ‘Inserting filter’.

5.2 Changing filter

Filters lose their efficiency after pro-
cessing about 50 l of water. “CHANGE
FILTER” appears in the display alter-
nately with the normal operating 
message, and the service button (fig.
1/I) flashes.  

Tip:

Only press the service button (fig.

1/I) when you wish to change filter.
You can continue to make coffee, hot
water or steam. How ever, we recom-
mend that you re place the filter im -
mediately.

➔ 

Empty the water reservoir (fig. 1/B

and 2) and replace the filter (see
point 4.2).

➔ 

Press the service button (fig. 1/I).

The display reads “CHANGE FILTER /
TURN VALVE”.

➔ 

Hold a container under the steam /

hot water jet (fig. 1/T) and turn the
valve control knob (fig. 1/Q and 7) to

the right to open. The system will now
be rinsed through.

➔ 

Wait until no more water comes out

of the jet for a short time and turn the
valve control knob (fig. 1/Q and 7)
back to the left to close. (

Caution:

If

water continues to come out of the
jet, the system is ready anyway. If this
occurs, still turn the control knob
back to the left.) 

➔ 

The system briefly warms up and is

then immediately oper ation al again.
The normal coffee-brew ing message
appears in the display.

Changing/ washing filter manually: 

Caution! 

If you use the machine infre-

quently, you must change the filter
after two months at most. No message
will appear in the display and you
must rinse the new filter manually.
You can set the replacement date
using the special rotat ing disk at the
top of the filter (scale in months).

➔ 

Empty the water reservoir (fig. 1/B

and 2) and replace the filter.

➔ 

Fill the tank with fresh water and

5. Maintenance and Care