Nivona CafeRomatica NICR7, Operating Instructions Manual

48

replace it in the machine.

➔ 

Press the program key 

P

to enter

programming mode. 

➔ 

Press the 

>

key until “PROGRAM

FILTER” appears.

➔ 

Press the 

ok

key. The display reads

“FILTER YES”. 

➔ 

Press the 

ok

key again. The display

reads “MANUAL CHANGE FILTER”. 

➔ 

Press the 

ok

key to confirm.

➔ 

“CHANGE FILTER” and “TURN

VALVE” appear alternately in the
display.

➔ 

Hold a container under the steam /

hot water jet (fig. 1/T) and turn the
control knob (fig. 1/Q and 7) to the
right to open. The system is rinsed out.

➔ 

Wait until no more water comes out

of the jet for a short time and turn
the control knob (fig. 1/Q and 7) back
to the left to close. (

Caution:

If water

continues to come out of the jet, the
system is ready anyway. If this occurs,
still turn the control knob back to the
left.) 

➔ 

The system briefly warms up and is

then immediately operational again.
The normal coffee-brewing message
appears in the display.

5.3 Cleaning program

When the machine needs to be clean-
ed, “PLEASE CLEAN” ap pears in the
display and the service button (fig. 1/I)
flashes.  

Tip:

Only press the service button (fig.

1/I) when you wish to start the clean -
ing program. You can continue to make
coffee, hot water or steam. How ever,
we recommend that you start the 
clean ing program as soon as possible.

Caution: 

Once running, the clean ing

program must not be inter rupted.
Only add cleaning tablet when the
machine instructs you to.

➔ 

Press the service button (fig. 1/I).

The display reads “EMPTY TRAYS”
alternately with “FILL WATER”.

➔ 

Remove the drip tray and used cof-

fee tray (fig. 1/Z and 1/U) and clean
them both.

➔ 

Fill the reservoir (fig. 1/B and 2)

with fresh water and replace it and
the tray (fig. 1/Z) in the machine.

➔ 

The machine rinses briefly and the

display shows “CLEANING TAB. INTO
/ POWDER SHAFT”.

Tip:

Place a sufficiently large container

(about 0.5 l) under the coffee spout
(fig. 1/J and 5).

➔ 

Put a cleaning tablet into the

ground coffee chamber (fig. 1/O) and
shut the lid. The display reads
“PRESS S KEY”.

➔ 

Press the service button (fig. 1/I).

➔ 

The machine starts the cleaning

operation.

➔ 

The cleaning operation runs auto-

matically and lasts about 10 minutes.
As soon as the cycle is complete, the
display shows “EMPTY TRAYS”.

➔ 

Empty, clean and replace the drip

tray (fig. 1/Z).

➔ 

Fill up the water reservoir (fig. 1/B

and 2) again with fresh water if re qui-
red.

➔ 

The machine warms up briefly and

is then immediately oper ational. 

Manual cleaning

If required, the cleaning program can
also be started even if no indication
has been displayed by the machine
that this is necessary:

... 5. Maintenance and Care