Installation and connection
Ex-Separator Module iXT0 - rev. 02 / 28.08.2017
page 23
12.3 Installation guidelines
For safe installation the measures below must be taken:
−
Do not subject the iXT0 to excessive vibration or shock
−
Do not install the iXT0 close to footpaths or travel ways
−
Observe the tolerable ambient air temperature
Strictly avoid when installing the device:
−
corrosive chemicals or gases
−
radioactive radiation
12.4 Fastening the iXT0
Note
Mounting materials and tools are not parts of the standard deliv-
ery.
−
For fastening use a DIN rail type TS35 according to EN 60715 with a mini-
mum length of 70 mm.
−
Fasten the rail horizontally in the intended enclosure/switching cabinet by us-
ing at least two screws.
−
Hook the iXT0 into the DIN rail from above and then is snapped into place di-
agonally downwards by exerting slight pressure from the front.
13 Electrical installation
WARNING
Disconnect the unit from mains power
All work on electrical connections may only be carried out with
the supply voltage turned off.
Observe electrical data specified on the nameplate.
Note
Observe the national installation instructions.
−
For electric installation the regulations in the respective countries must be re-
ferred to.
