®
Instruction Manual
NivuCompact
page 28
NivuCompact – Rev. 05 as of 31.10.2012
8
Program mode
8.1
General
Programming the NivuCompact is carried out in various menus where the
individual parameters are stored related to their functions (see chapter 9).
To access the
Program mode
press the
and
button (ESC and ENTER)
simultaneously, where upon the display will show
PASS
on the LC display
briefly, to prompt you to enter the password P922 (default = 1997).
The display will now show
0000
, and the left hand digit will flash. By using the
>
UP< und >
DOWN< keys to increment or decrement the digit, and the
ENTER key
to shift the flashing digit to the next position. Please proceed as
described in order to complete the 4-digit access code. Press ENTER
again
to confirm the access code. If your entry was successful the display will indicate
>APP< for application. If however you input the wrong pass code the
NivuCompact LC display will show “Fail” for 2 seconds and will revert back to
operation mode.
To get from parameter setting menu to operation mode press >ESC< several
times until the display indicates >run< and confirm with >ENTER< subsequently.
The NivuCompact will jump to operation mode automatically if no entry (key
action) has been registered in parameter setting mode for 10 minutes.
8.2
Navigating in set-up menu (parameter menu)
If you are in the set-up menu the NivuCompact will show APP (Application).
Pressing the >
UP< and >
DOWN< buttons will scroll the display between
the menu items. Pressing the >
ENTER< key takes you to the selected
menu. To exit simply press >
ESC<.
Example 1:
Press the „UP“-button 1x to get into the Relay menu (abbreviation rL)
To stay in the Relay menu press >ENTER<. With the >UP< and >DOWN<
buttons you can get to the parameters in the sub-menu.
Example 2:
You have chosen the menu diSP (Display menu) and you want to change the
unit in P800:
Fig. 8-1
P800 in display menu
