6 Installation
NivuLink Micro - Rev. 02/13.11.2018
page 33
6.6 Electrical installation
6.6.1
Safety notes on cabling
WARNING
Risk of electric shock
−
Before connecting the sensors / actuators, power off the NivuLink Micro.
−
Only connect cables when they are de-energized.
WARNING
Risk of disturbance due to electrical interference
−
To avoid disturbances from electrical interferences, the sensor cable must
not be laid close to (or parallel to) engine (motor) supply lines or high volt-
age power lines. The installation of sensors in open flumes, channels or
water bodies always requires preceding planning. Installation options here
are highly individual.
−
Any work on electrical connections should be carried out with the power
supply disconnected.
CAUTION
Personal or material damages due to improper handling
−
To prevent possible damages the installation as described in the following
chapter should be carried out by qualified personnel only.
−
Observe all applicable legal and operational guidelines and requirements.
−
Prior to beginning installation works necessarily ensure compliance with all
occupational health and safety regulations.
CAUTION
Risk of tripping or damage due to improper layout of cables
Lay the cables so as to protect them from
−
being walked on or pinched
−
sharp bends and curves
CAUTION
Device damage from electrical power
Before making the electrical connections, switch off the power supply / disconnect
the battery.