Chapter 8 Initial Start-Up
Chapter 8 Initial Start-Up
8.1 User information
Before you connect the NivuLog Easy and place it into operation, you must observe and comply with the fol-
lowing user information!
This manual contains all information that is required for using the device.
Is intended for technically qualified personnel who have the relevant knowledge and experience in the area of
measurement technology.
Read this manual carefully and completely in order to ensure the proper functioning of the NivuLog Easy .
Please contact our technical department if anything is unclear or if you encounter difficulties with regard to
installation, connection or configuration (see "Branch offices " on page 73).
If necessary, please also refer to the manuals of the accessory parts when commissioning the complete sys-
tem. These manuals are included in the scope of delivery of the accessory parts.
8.2 General principles
The entire measurement system may only be placed into operation after completion and inspection of the
installation. Study the manual thoroughly before placing into operation to prevent faulty or incorrect con-
figuration.
Utilise the manual to familiarise yourself with the operation of the NivuLog Easy and the input screens of the
Device to Web-Server before you begin with the configuration.
8.3 Placing the system into operation
Note:
It is recommended that the NivuLog Easy is first placed into operation in the office before permanently
mounting the device at the place of use. In doing so you should set a site for the later operation on the Device to
Web server (see "Device to Web Server Manual " - upon request) and determine a site configuration (see "Site
configuration" on page 37). Take the opportunity to get to know the functions of the device in a stable envi-
ronment. You can also use suitable test signals to simulate the sensors to establish the optimum configuration
of the NivuLog Easy prior to its actual first use. This will reduce the time needed for on-site installation to a mini-
mum.
1. Once you have completed all of the steps described in the section "Connecting the sensors, actuators
and supply" on page 24, the NivuLog Easy is ready for operation and should have already made its first
connection to the Device to Web server.
2. Create a site for the operation on the Device to Web server (see "Device to Web Server Manual " -
upon request).
3. Configure the created site according to your requirements (see "Site configuration" on page 37).
4. Link the NivuLog Easy with the created site (see "Site" on page 37).
5. Check whether the type of accu pack set in the device configuration (see "Device-specific settings" on
page 62) matches the accu or battery pack that is being used.
NivuLog Easy - Rev. 05 as of 02.07.2012
31 of 73
