9.2.1.4.2 Calculation
Off
---
Calculated channel deactivated
Table
Source
Selection of the channel from which the input data is used
Opens the screen for entering the values table (between the table rows is
interpolated linearly, values outside of the defined table are extrapolated
linearly.)
Digital
Source
Selection of the channel from which the input data is used
High level
Signal recognition level
+, -, x, /
Source
Selection of the channel from which the input data is used
+, -, x, /
Source
Selection of the channel from which the input data is used
9.2.1.4.3 Alarm
Note:
The alarm levels for calculated channels can only be evaluated once the device has transmitted the
measurement data to the Device to Web server.
Alarm low
An alarm is initiated if the measurement value drops to or below this value.
Alarm high
An alarm is initiated if the measurement value meets or exceeds this value.
Hyst %
Hysteresis for all-clear (e.g. hyst = 5%, alarm or warning at 100 -> all-clear at 95)
9.2.1.5 Output channels
9.2.1.5.1 Basis
Ext warmup time
Indicates the amount of time that an output channel is switched on in "Ext warmup time" mode before
the measurement.
Title 1
Freely selectable channel title for the switchable sensor supply
Title 2
Freely selectable channel title for the isolated switch contact
54 of 73
NivuLog Easy - Rev. 05 as of 02.07.2012
