Chapter 9 User interfaces
Mode
Basic setting for the output channel
Off
---
Output channel deactivated
Ext warmup
time
The output channel is switched on "ext warmup time" seconds prior the to
measurement. If the value is "0", the output channel is not switched on at all.
Digital
Invert
Inverts the level issued by the device (see "Additional explanation of
"Digital" mode" on page 56).
Setpoint
Setpoint (on/off) that should be issued
Frequency
Factor
The frequency in Hertz is determined by multiplying the setpoint by
the factor.
Min
Defines the lower scale end of the pointer instruments
Max
Defines the upper scale end of the pointer instruments
Setpoint
The frequency in Hertz is determined by multiplying the setpoint by
the factor.
Unit
String, which is used as the measurement unit by all of the server
display elements
Decimal places Number of decimal places that are used by all of the server display
elements
PWM
0%
Start of measurement range in the measurement unit
100%
End of measurement range in the measurement unit
Setpoint
Output value in the measured unit
Unit
String, which is used as the measurement unit by all of the server
display elements
Decimal places Number of decimal places that are used by all of the server display
elements
Impulse
Factor
The impulse/min is determined by multiplying the setpoint by the
factor.
Min
Defines the lower scale end of the pointer instruments
Max
Defines the upper scale end of the pointer instruments
Setpoint
The impulse/min is determined by multiplying the setpoint by the
factor.
Unit
String, which is used as the measurement unit by all of the server
display elements
Decimal places Number of decimal places that are used by all of the server display
elements
NivuLog Easy - Rev. 05 as of 02.07.2012
55 of 73