9.2.1.8 Basic settings
Connection type
Cycle
The device registers in the transmission cycle
Cycle & wakeup
The device registers in the transmission cycle and can be
placed into the ALOHA transmission mode via the server.
Online
The device does not disconnect the connection and
continuously transmits the measurement data.
Aloha/wakeup duration
Aloha/wakeup duration connection
Transmission cycle
Time between transmissions
Recoding cycle
Time between measurement data recordings
Measure quick divisor
Recoding cycle = recording cycle / factor (from triggering)
Measure slow factor
Recoding cycle = recording cycle * factor (from triggering)
Measurement cycle
Time between measurements (00:00 same as recoding cycle)
Burst cycle
Period of time, during which measurement intervals are used for measuring,
before recording begins. (00:00 measurement cycle is permanently activated)
Time zone
Regional setting (not relevant for raw measurement data as this is stored in the
UTC)
Daylight saving time
Configuration for automatic time adjustment
Standard
The configuration for the time adjustment is adopted by the
global server setting (see "Device to Web Server Manual "
- upon request).
Off
Automatic time adjustment deactivated
USA
Predefined setting for the American area
EU
Predefined setting for the European area
Position cycle
Time between position update
Default view
Report, which is loaded into the map by clicking on the device link
58 of 73
NivuLog Easy - Rev. 05 as of 02.07.2012
