Chapter 6 Storage, delivery and transport
Chapter 6 Storage, delivery and transport
6.1 Inspection of incoming deliveries
Please check the shipment immediately after receiving for completeness and intactness. Immediately report
any discovered transport damages to the delivering carrier. Also notify the manufacturer in writing about this
without delay. Report any incompleteness in the delivery to the responsible representative or directly to the
company headquarters of the manufacturer within 2 weeks (see "Branch offices " on page 73).
Note:
Any claims received thereafter will not be acknowledged!
6.2 Scope of delivery
Note:
The accu or battery pack required for operation, (see "Accu and battery packs" on page 71) is
not part of the standard scope of delivery and must be ordered separately.
The standard scope of delivery of the NivuLog Easy (206.210) includes:
l
NivuLog Easy
l
Tool Pen (NLM0TOOLPEN)
l
10-pole connector plug
l
Magnet for device activation (NLM5MAGNET)
l
Quick guide
Additional equipment such as internal extensions, assembly sets, antennas, accu or battery pack, sensors,
power supply, charger, etc., depending on the order. Please check this against the delivery slip.
6.3 Storage
The following storage conditions must be observed:
NivuLog Easy
Storage temperature
-30...+85°C
Humidity
15...90%rH
BP434R
Operating temperature
-20...+50°C
Storage temperature
0...+35°C
Operating temperature
-50...+60°C
Charging temperature
-20...+60°C
Storage temperature
0... +30°C
Note:
The table above only includes the storage conditions for the two energy sources used most frequently for
the NivuLog Easy . Please consult the appropriate factsheet for information about the storage conditions of
other accu or battery packs.
Important note:
Remove the accu or battery pack from the NivuLog Easy prior to storage.
Store the measurement technology so that it is protected against corrosive or organic solvent vapours, radio-
active emissions and strong electromagnetic radiation.
NivuLog Easy - Rev. 05 as of 02.07.2012
19 of 73