User Manual
n’Joy Protector 801
650VA / 325Watts
Step-Sine Wave
Thank you for purchasing our product. Please read the
USER’S MANUAL
before using the product.
The UPS will protect your electronic equipment from
physical damage and will provide emergency battery
backup power to prevent data loss in the event of power
problem.
Features
Smart Microprocessor Control.
Automatic Voltage Regulation for Low Input Line.
Overload and over voltage protection.
USB Connectivity.
DC direct starts up capability, complete diagnostic
indication and control.
Intelligent Battery Management.
EMI/RFI Noise Filter.
Lightning and Surge Protection.
Fax/Modem Surge Suppression Port.
Coaxial Surge Protection.
Installation
Note: The UPS is build of six protected outlets, 3 connected to the battery
(UPS) and 3 which provide protection (Surge) without the possibility of
further electric energy supply for the equipment when the power is off.
The UPS can protect your equipment from all power
problems such as surge, spikes, blackouts, brownouts and
line noise. When AC power is present and the ON/OFF
switch is turned on, the UPS is always charging the battery
and providing the power to the equipment from AC line
directly. The reliable battery can provide the stable power
to complete your work, save the data and safely shut down
your system when the utility power is blackout. The UPS is
simple to operate and install. Following is the step of
installation before the equipment connects to the UPS.
1.
Connect the UPS to grounded AC power Outlets.
2.
Please turn on the ON/OFF switch and charge the
battery at least
8 hours
for fully charge before you
use the UPS.
3.
Plug your computer and monitor into the “Battery
Backup & Surge Protection” outlets. (These
outlets will provide emergency battery backup
power during power problems as well as surge
protection from surge and spike).
CAUTION:
Do
NOT
plug
LASER PRINTERS
into any
of the “Battery Backup & Surge Protection” or
“Surge Protection” outlets.
CAUTION:
Do NOT plug
ACCESSORY SURGE
strip
into any of the “Battery Back & Surge Protection”
outlets.
4.
Connect the USB cable to your computer.
5.
Plug your peripheral equipment (printer, tv
scanner, fax, speaker etc.) into the “Surge
Protection” outlets. (These outlets will
NOT
provide battery backup power during a utility
power failure.
6.
Connect the network / internet lines to the UPS
outlet.
7.
Turn on the UPS.
Indicators
Note: This UPS is supplied with Schuko type
sockets
.
