to significantly affect its safety or effectiveness is
NOT
recommended.
3.
Please always disconnect the input power cord from
the wall outlet before replacing the battery.
4.
Do
NOT
dispose of battery in a fire. The battery may
explode.
5.
Do
NOT
open or mutilate the battery. They contain an
electrolyte that is toxic and harmful to the skin and
eyes.
6.
Proper disposal of battery is required. Please refer to
your local laws/regulations regarding to battery
disposal.
7.
Using tools with insulated handles to replace the
battery to avoid personal injury. Due to energy hazard,
please remove wrist watched and jewelry such as rings
when replacing battery.
Troubleshooting
Symptom
Possible
Cause
Action to Take
UPS can not
turn on.
On/Off
switch not
pushed
completely
Press and hold the On/Off switch for
3
sec. Or until you hear a beep sound.
Battery
voltage is
too
low.
Call for service.
UPS always at
battery
mode.
Power cord
loose.
Re-plug the power cord firmly.
Circuit
breaker
tripped.
Remove some loads and reset circuit
breaker.
Line voltage
too high
or too low.
Check input voltage.
UPS is normal
but the
computer
won’t turn on
Computer
input
power cord
is loose
or not
connected.
Reconnect computer input power
cord
Connected
equipments
lose
power while
connected to
the
UPS.
The “Battery
Backup
& Surge
Protection”
outlets are
overload.
Refer to the Symptom overload.
Remove the non-critical loads and
start
the UPS again.
The UPS has
exhausted its
available run
time.
The UPS will turn off when the
battery
has been depleted during the failure
of
utility power. Allow UPS to re-charge
before continuing using of the UPS.
The UPS will
Ensure the equipment that you want
turn off
when the
battery
has been
depleted
during the
failure of
utility power.
Allow UPS to
re-charge
before
continuing
using of the
UPS.
to
stay powered during a failure of
utility
power is plugged into the “Battery
Backup & Surge Protection” outlets.
The UPS may
be
faulty.
Call for service.
Specification
Model
n’Joy Protector 801
Power
650VA / 325W
Nominal Input Voltage
230Vac
Input Voltage Range
172~272Vac
Nominal Output Voltage
230Vac
Output Voltage Range at
Line
+18% ~ -15%
Output Voltage Range at
Line
-40%
Frequency
50 / 60 Hz Auto detection
Outlets
6 Outlets (3 Battery Backup &
Surge Protection; 3 Surge
Protection only)
Lighting / Surge
Protection
480 Joules
Transfer Time to Battery
/ AC
< 4 ms
Battery Type
Sealed and leak proof
maintenance free lead-acid
battery
Battery Specification
12V/7AH x 1
TYpical Backup Time
10 ~ 15 min
Internet Protection
RJ45 (1 in / 1 out)
Coaxial Surge Protection
1 in / 1 out
Communication Port
USB
Operation Temperature
+32 ~ 104 (0 ~ 40)
Operation Relative
Humidity
0 to 95% without
condensation
Storage Temperature
+5 ~ 113 (-15 ~ 45)
Net Weight
13.9 lbs / 6.3 kg
Dimensions (DxWxH)
272x174x112mm
Agency Approval
CE
* Specification change without notice.
