8
9
Installing your UPS system
4
4.1 Hardware installation guide
1. Placement & Storage conditions
Install the UPS in a protected area that is free of excessive dust and
has adequate air flow. Please place the UPS away from other units at
least 20 cm to avoid interference. Do NOT operate the UPS where the
temperature and humidity is outside the specific limits. (Please check the
specs for the limitations.)
2. Connect to utility and charging
Plug in the AC input cord to the wall outlet. For the best results, suggest
to charge the battery at least 6 hours before initial use. The unit charges
its battery while connecting to the utility.
3. Connect the loads
Plug in the loads to output receptacles on the front panel of the UPS.
Simply turn on the power switch of UPS unit, then devices connected to
the UPS will be protected by UPS unit.
Due to its high-power consumption, we do
NOT
recommend
connecting
LASER PRINTERS
or loudspeaker equipment
such as
SUBWOOFERS
to this type of UPS.
Do
NOT
plug any
SURGE STRIPS
into any of the outlets.
CAUTION
4. Connect communication cable
To allow for unattended UPS shutdown/start up and status monitoring,
connect the communication cable one end to the USB port and the other
to the communication port of your PC. With the monitoring software
installed, you can schedule UPS shutdown/start up and monitor UPS
status through PC.
5. Connect Modem/Phone /Network for surge protection
Connect a single modem/phone line into surge protected “IN” outlet
on the side panel of the UPS unit. Connect from “OUT” out let to the
computer with phone line cable.
6. Turn On/Off the unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit
by pressing again the power switch.
4.2 Software installation guide
Install software: For optimal computer system protection, install the UPS
monitoring software from
https://www.power-software-download.com/
viewpower.html
to fully manage the UPS.
Indicators
5
5.1 LED indicators (for Token 600 model)
LED
Alarm
UPS Status
Green (LED on)
Off
The mains is normal and
UPS is operated normally.
Yellow (LED flashing)
Sounding every
10 seconds
Power failure occurs and
UPS is on battery mode.
Yellow (LED flashing)
Sounding every
second
Low battery
Green (LED off)
Off
UPS is off.
Red (LED on)
Continuously
sounding
UPS fault
Red
Yellow
Green
Summary of Contents for Token 600
Page 15: ......