6
7
5-2. Pre-installation
Before making connection to environmental monitor device, make sure the
UPS is already installed with SNMP manager. Please check SNMP manager
for SNMP card installation.
5-3. Wall-mounting
There is a mounting hole on the back of the unit. Simply mount the unit by
position the key-hole slot over the mounting screw. (See
chart 1
)
Chart 1
5-4. Connect to power
Please follow
Chart 2
to connect an external 12VDC power source. If
connecting to SNMP card, there is power from SNMP card. It’s no need to
connect an external power source.
NOTE!
To guarantee safety operation, please use the appropriate DC wire with UL2468
#24AWG spec.
Chart 2
5-5. SNMP Connection
Connect supplied cable from communication port of environmental monitor
device to RS-232 port of SNMP manager. Use another network cable to
connect from RJ45 port of SNMP manager to LAN. (Refer to
chart 3
).
Chart 3
NOTE!
If supplied cable is not long enough for your application, you may substitute another
longer cable (not exceed 15m).
5.6 Operation
After making connection, status LED will light up and the unit starts to operate.
Monitoring software operation
6
6-1. Software installation
After unit is connected well, please follow below steps to install monitoring
software from the internet.
1. Go to the website
http://www.power-software-download.com
2. Click ViewPower Pro software icon and then choose your required OS to
download the software.
3. Follow the on-screen instructions to install the software.
4. When your computer restarts, the monitoring software will appear as an
orange plug icon located in the system tray, near the clock.
6-2. Operation
Step 1:
Doubleclick“ViewPowerPro”iconto
launchthesoftware.
Summary of Contents for UPAC-TEMPHUM-AZ01B
Page 7: ......
