53
Enabling emission from an individual BOOSTIK module
Enabling emission from an individual BOOSTIK module
To enable emission from an individual BOOSTIK module inserted in an
ACOUSTIK system, follow the steps in
.
Note:
The modules are equipped with internal temperature sensors that monitor
the temperature of sensitive components. If these components are outside their
specified temperature range, emissions are disabled.
7
a
Set the reference wavelength offset for
the module using the slider in the
Wavelength offset
setting control. To
adjust the wavelength, click-hold the slider
to change its position.
b
Alternatively, enter the wavelength in
nanometer units by typing the value into
the offset input field at the upper right
corner.
c
For a module with power control, set the
emitted power level using the slider in the
Power
setting control. To change the
power, click-hold the red slider to change
its position.
d
Alternatively, enter the power level in dBm
or mW units by typing the value into the
power input field at the upper right corner.
8 To disable emission – with the module still
selected, click the Emission button once.
Action
λ
offset input field
P slider
P input field
λ
offset slider
Click once to
disable emission
Status indicator turns
ON AMBER and Emission
indicator turns OFF
Summary of Contents for Koheras ACOUSTIK
