www.stingerworld.com
IMPORTANT INFORMATION
!
2
PERSONAL SAFETY ITEMS
•
Do not use tool prior to reading the Owner’s Manual.
•
Always wear eye protection that conforms to ANSI requirements (Z87.1) and
provides protection against flying particles both from the front and side. Eye
protection should be worn by the operator and by others in the work area. Eye
protection is required to protect against flying fasteners and debris that could
possibly cause severe eye injury.
•
The employer is responsible to enforce the use of eye protection equipment by the tool
operator and all other personnel in the work area.
•
To prevent accidental injuries:
–
Handle the tool with care
–
Always assume that the tool contains fasteners
–
Always disconnect the air hose from the
STINGER CS150
when:
•
loading staples and/or caps
•
performing inspection, maintenance or repair
•
clearing a staple or collated cap jam
•
the tool is not in use
•
leaving the work area
•
moving the
STINGER CS150
to another work location
•
handing the
STINGER CS150
to another person
•
storing the tool
–
Never point the tool toward yourself or anyone else
–
Never engage in horseplay
–
Never hold or carry the tool with a finger on the trigger
–
Never place a hand or any other part of the body in the fastener discharge area of
the tool while the air supply is connected
