www.stingerworld.com
IMPORTANT INFORMATION
4
OPERATION OF THE TOOL
•
Never inspect, maintain, repair, adjust, clear a jam or store the tool with the air connected.
•
Never use the tool in proximity of flammable gases or liquids, as some tools will create sparks
that can be an ignition source for a fire or explosion.
•
Always inspect the safety device for damage and proper operation prior to operation.
•
Never assume the tool is empty of fasteners.
•
Never point the tool toward yourself or any other persons.
•
Never cycle the tool unless it is in contact with the work-piece.
•
Never use the tool as a hammer or wedging device or drop to the floor from any height.
•
Always remove your finger from the trigger when pausing from cycling.
•
Never tamper with the safety device or use the tool if the safety device is not functioning
properly.
•
Use only
7/8”, 1
¼
” or 1
½
”
STINGER StaplePac
®
cap fasteners with the
STINGER CS150
Cap Stapler. Never use any fasteners that are not specified for use in this tool. The
CS150
holds 1 coil of plastic caps (200 caps) and 2 strips of staples (100 staples each).
