Use and maintenance manual model “UNICA 10 V/C” - WOOD
ENGLISH
17
As soon as the batteries are completely flat,
remote communication with the appliance will
stop and the remote control will display a full-
screen image of a flat battery, blocking all the
functions connected to it until the batteries are
replaced.
7.5 ICON LIST - WOOD
1
2
3
MEANING
TURN ON (WOOD) OR
SWITCH TO WOOD MODE
OPERATION (WOOD MODE)
WOOD SAVING MODE
WOOD FINAL CLEANING
REMOTE CONTROL
BATTERIES ALMOST FLAT
ALERT
(see specific paragraph)
LOAD MORE WOOD
(see specific paragraph)
WARNING
(see specific paragraph)
7.6 POWER MANAGEMENT
From the standby screen, press the
←
key
(paragraph 7.3) to access Unica’s power
management contextual menu for pellets
and wood. It is also possible to set canalization
operating modes, when installed (optional) and
enabled.
The menu is useful when you want to adjust the
operating power to restart the appliance in pellet
mode while Unica is running with wood.
8
NAVIGATION MENU
See the corresponding paragraph in the PELLET
manual.
9
START-UP INSTRUCTIONS
This chapter highlights a series of operations
to be carried out during the first start-up of the
appliance.
34 cm.
primary air
tertiary air
secondary
air
DO NOT OVERLOAD!
- SEE CHAPTER 2 FOR
RECOMMENDED WOOD TYPE AND QUANTITY.
Load wood when Unica requests it (provided you
have not disabled the prior-notification function)
and only when intense ember are present. To
avoid serious damage due to overheating,
not
covered by any type of warranty
, do not leave
the primary air (manual operation) completely
open while using the generator without electricity
(“forging effect”).
9.1 DATE AND HOUR SETTINGS
See the corresponding paragraph in the PELLET
manual.
9.2 ROOM PROBE SETTINGS (
remote
control
)
See the corresponding paragraph in the PELLET
