INSTRUCTION MANUAL
•
5
BATTERY INSTALLING & REPLACEMENT
HOW TO USE
1. Keep the body straight up
when the LED light is flashing.
2. Unscrew the screws and pick
out the battery container.
3. Insert or replace all batteries
(6 AA). Insert bracket into unit
and screw into place.
1. Insert key into lock on top of
the unit to open the top cover.
After batteries are installed,
hold the adjustment button for
3 seconds. The LED light will
flash 3 times to indicate that
the unit is on.
2. After top cover is removed,
open sealing cap and fill unit
with foam soap or sanitizer.
Clean any overflowing liquid
from the unit, and replace
the cap on the unit.
3. Wave hands under sensor
until soap or sanitizer begins
to dispense. Note that the unit
may require multiple senses
to activate before dispensing
soap or sanitizer.
Indicator
Key
Cap
Indicator
Quantity
Adjustment
Button
Sealing
Cap
Fixed
Bracket
Battery
Cover
Screw
CAUTION
WARNING
• After installing batteries, hold soap or sanitizer adjustment button for 3 seconds.
LED light will flash 3 times. At that point, the unit will enter standby mode.
Hold the soap or sanitizer adjustment button for 3 seconds to return the unit to sleep mode.
• Please keep batteries installed in unit even while in storage. If no use has been detected
in 72 hours, the unit will automatically run once in order to avoid tube adhesion.
• Children using the unit must be accompanied by an adult to avoid injury or malfunction.
• Please ensure proper disposal of depleted batteries.
• Keep unit dry at all times to avoid electrical malfunction.
