INSTRUCTION MANUAL
•
6
QUANTITY ADJUSTMENT
• While unit is in standby, amount of soap or sanitizer
dispensed per activation can be adjusted with the
quantity adjustment button on top of the unit.
• Default output volume is roughly 1 ml per use.
• Output will be increased by .5ml per button press.
• There are 5 total levels of output, ranging from .5 - 2.5ml.
• Output may change slightly depending on type of liquid.
Quantity
Adjustment
Button
Indicator
TROUBLESHOOTING
• TIP: Keep fluid container clean and free of dirt and dust to avoid blockages.
Problem
Reason
Potential Solution
LED INDICATOR OFF
Control System Trouble
Replace the Controller
Power Supply Problem
Check Circuits and Batteries
Batteries - Poor Contact or Out of Power
Reinstall or Replace Batteries
Circuits - Problem or Poor Contact
Check Circuits
Indicator Sight Blocked
Clean the Indicator Window
LED LIGHT FLASH
Not Enough Power
Replace Batteries
INDICATOR ON WITHOUT
SOAP OR SANITIZER
SUPPLY
Sensor Continue Working
Remove Sensing Object
Out of Sensing Distance
Place Hand Directly Below
Sensor, Slowly Move Side to Side
and Up and Down Until Soap
Dispenses
Unit Fault
Contact the Dealer
INSUFFICIENT SOAP OR
SANITIZER SUPPLY
Short Soap or Sanitizer Supply Time
Adjust Soap or Sanitizer Output
Soap or Sanitizer is Too Viscous
Reduce Soap or Sanitizer
Viscosity
Soap or Sanitizer Coagulation or
Obstruction
Try Clearing Lines or Contact the
Dealer
