67
·According to
《
operation and maintenance manual
》
of the used charger to break
charging procedure.
·Do not pull out charger plug during charging, otherwise there will be spark take place
to lead to danger.
(2) Replace bettery
When forklift has been used continuously for a working period and the battery has entirely
excharged,replace the battery with another fully charged one and charge the battery been
replaced.
·
In replacing, to be sure that new battery mates with forklift well, otherwise there will
be dangerous to shorten lifespan of forklift or overturn during traveling.
·Replacement of battery shall be done on level table.
According to the steps as below to replace battery:
·When using another forklift as hoisting equipment to lift battery, you shall choose a
proper lifting tool(accessary).
·Only qualified person can operate battery.
(a) Pull out plug of battery.
(b) Open upper cover of battery.
Use gas spring or other methods to ensure block upper
cover of battery to avoid cover fall down to injure human or
bodywork.
(c) When hoisting battery out forklift, be careful for
touching steering wheel or other forklift parts.
(d) After finish installation of battery, connect and fasten
the battery pin.
(e) Close upper cover of battery.
·
When close upper cover of battery, be careful to injure
your finger.
·During hoisting battery, be careful to prevent swing of
battery box to injure bodywork.
10
．
Stacking
·Check the following items before operation:
(a) Be sure that there are no falling of load and damaging
of load in loading region.
(b) Be sure that there is no goods or pile
possible leading to unsafety
Stack as follows:
(1) Slow down when getting close to goods.
(2) Parking in front of goods.
(3) Check the safety of goods area.
(4) Adjust the position of vehicle until it lies in front of goods
(5) Make Mast vertically ,lift fork up more than the height of goods.
(6) Check goods’location and park the vehicle to optimum position.
(7) Ensure that the load higher than the stacked goods and lower
fork slowly and place load correctly and safely.
·Before load placed on shelves or bracket:
(a) Lower load until fork no longer carry any load.
