11
SOLUTION TANK FILLING
1. Open the fill-port lid in the front of the machine.
2. Fill the cleaning water or suitable detergent with hose. The solution tank water level can be checked
by the indicator hose on the side. When the float ball reaches "F" position, the solution water tank is full.
The temperature of the filling water or detergent shall not 104F (+40°C).
NOTE
When the float ball exceeds "F" position, excess water will be spilled from
the top of the water level indicator hose. Avoid the float ball exceeding
the "F" position when filling water.
WARNING!
Use only low-foam and non-flammable detergent, which should be
suitable for the scrubber.
START AND STOP OF MACHINE
1. Prepare the machine as shown in previous paragraph. Operator sits on the seat and turn the key
switch to "ON" position. If the BDI display 100% of battery charge, it means the battery is fully
charged and available for use. If the BDI displays 10%, the battery needs to be charged. Turn the key
switch to "OFF" and charge the battery fully. (See Maintenance Chapter)
2. Press the "brush motor button" and "vacuum motor button", the indicator light will be on, the
squeegee and the brush will be automatically lowered to the ground. Brush motor and vacuum motor
start running.
3. According to the cleaning demand, the solution liquid flow can be adjusted through the "solution flow
button" on the control panel, three different flows are available. Three indicator lights on indicates the
maximum flow. Visually check the water level indicator hose on the side of the solution tank. When
the float ball reaches the bottom, the water of the solution tank is going to be empty, fill the water
accordingly.
4. The speed of the machine can be adjusted through the "tortoise/rabbit button" on the panel. Press
the "tortoise button" to decelerate, and press the "rabbit button" to accelerate. Three levels of speed
are available. Speed can be adjusted by operating the accelerator pedal, the more force on the pedal,
the faster machine travels. Reduce the force on the accelerator pedal slowly, move the steering
wheel and start scrubbing.
5. Press the "R" button to move the machine backwards. When the machine backward, the squeegee
assembly and brush disc will be automatically lifted and the machine stops cleaning automatically.
6. In case of sudden crowd or crowded situation, operator can press the "horn button" for warning, the
machine will issue a "beep" sound.
7. If work in the dark area, press "front lamp button" to turn on the front LED lamp.
8.
Press “emergency button" to stop the machine immediately in case of emergency.
9. Release the accelerator pedal to stop the machine.
