12
10. Press the "brush motor button" and "vacuum motor button" again, the indicator light will be off and the
squeegee and the brush will be automatically lifted. The brush motor shuts down and the vacuum
motor shuts down after a few seconds.
11. Make sure to park the machine and turn the key switch to "OFF" position.
CAUTION!
To avoid any damage to the floor surface, turn off the brush/pad driver
when the machine stops in an area.
CAUTION!
Do not use the machine when the battery charge is low, to avoid damaging
the batteries and reducing the battery life.
DRAINING TANKS
1. The float shut-off screen will block the inspiratory path of vacuum motor when the recovery tank is full,
and the vacuum motor can not suck the floor dry. Please stop working immediately.
2. Turn off the brush motor and vacuum motor to lift the brush disk and squeegee assembly.
3. Move the machine to the designated drainage area.
4. Drain the recovery tank through the drain hose, then rinse the recovery tank with clean water.
WARNING!
When the recovery tank is full, please stop working immediately to avoid
sewage entering the vacuum motor.
DRAINING SOLUTION TANK
Unscrew the solution tank tap cover under the accelerator pedal to drain the solution liquid.
AFTER USE
After working, complete the following steps before leaving the machine:
1. Remove the brush disk/pad driver according to the procedures shown in previous chapter.
2. Drain the solution tank and recovery tank according to the procedures described above.
3. Perform the daily maintenance procedures (see the maintenance chapter).
4. Store the machine in a clean and dry place, with the brush disk/ pad driver and the squeegee lifted
or removed.
AFTER LONG-TERM INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in chapter of After Use.
2. Disconnect the battery and the machine.
