16
It is advisable to wear protective gloves when cleaning the squeegee in case of the
injury by the sharp debris.
1. Loosen the knobs on the squeegee assembly and remove the vacuum hose from the squeegee.
2. Clean the aluminum bracket squeegee and the vacuum hose. Check the front blade and the rear
blade for integrity, cuts and tears; replace them if necessary.
3.
Assemble the squeegee in the reverse order of disassembly.
SQUEEGEE BLADE CHECK AND REPLACEMENT
1. Check the edges of front blade and rear blade for integrity, cuts and tears; if the bottom edge of the
blade is worn, turn it upside down (the top edge is intact). If the top edge is worn, replace the blade
according to the following procedures:
2. Loosen the buckle, release pressure strip from the retainers and remove the retaining strip. Replace
the worn blade and assemble the new rear blade in the reverse order of removal.
3.
Unscrew the knob and remove the retaining strip, then replace the front blade. Assemble the front
blade in the reverse order of removal.
RECOVERY TANK CLEANING AND CHECK
1. Drain the recovery tank by drain hose.
2. Open the recovery tank and remove the recovery tank lid, then rinse the recovery tank lid and
recovery tank with clean water.
3. Check whether the bearing surface of the sealing of the recovery tank is intact and sealed, remove
the sealing from the tank and replace it if necessary.
4. Fit the recovery tank lid in place.
