18
(1) Power display: 10 grids indicate 100% charge, each grid represents 10% charge, every 10%
discharge with power out of one grid, if the remaining charge is less than 20%, the grids on the
display screen flashes. When the battery is charged to the recovery voltage of the indicator, the
display screen will show full recovery charge grids. Every time you turn on the display, the record/
memory is available;
(2) Hour-meter display: the working time of the truck is recorded in unit (hour) with accuracy of 0.1
hour. Every time you turn on the display, the record/ memory is available;
(3) Fault code display: it consists of two parts. One is the wrench symbol: wrench symbol showed
on the screen indicates the fault of the truck, it will not be on the screen without fault; The other part
is fault code: when the wrench symbol is displayed on the screen, the original position of the
hour-meter displays the fault code. See the table of fault codes for details.
(4) Turtle speed display: the turtle symbol is normally off. Press the turtle speed button on the tiller,
then the turtle symbol will display on the screen and the truck is in slow speed;
(5) Timing hourglass display: when the hour timing function of the tiller is activated, the hourglass
symbol displays on the screen, if not, the hourglass symbol will not display.
c.
Charging
•
Ensure that you charge the battery with appropriate charger.
•
Please fully understand the instructions for the charger before using it.
•
Always follow these instructions.
•
The room, where you are charging must be ventilated.
•
The full charge status can be only checked from the discharge indicator. To control the status,
the charging must be interrupted and the truck must be started.
Park the truck at a dedicated secured area with a dedicated power supply.
Lower the forks and remove the load;
Open the battery cap and keep it in vertical state.
Switch off the truck and connect the connector and the charger, then connect the charging plug to the
power supply.
The charger starts charging the battery.
Disconnect the charger plug from the battery after the charger is completed.
Well connect the connector to the truck.
Close the battery cap.