16
e. Travelling
TRAVEL ON INCLINES ONLY WITH THE LOAD FACING UPHILL
.
DO NOT TRAVEL ON INCLINES MORE THAN SPECIFIED WITH THE TECHNICAL
DATA.
TRAVELLING IS ONLY ALLOWED IF THE FORKS ARE LOWERED DOWN TO THE
LIFTING POINT (<300MM).
After starting the truck by activation from Pin-code panel carefully move the tiller to the operating zone
(‘F’, fig.11).
Turn the accelerator button to the desired direction forward ‘Fw.’ Or backwards ‘Bw.’(fig. 11).
Control the travelling speed by moving the accelerator button (Fig.7, 26) carefully until you reached the
desired speed. If you move the accelerator button back to the neutral position, the controller
decelerates the truck until the truck stops. If the truck stopped, the parking brake will be engaged.
Drive carefully the truck to the destination. Watch the route conditions and adjust the travelling speed
with the accelerator- button.
Press turtle button (Fig.7, 30) to enter into slow speed mode, travel slowly by moving the accelerator
button (Fig.7, 26) , press turtle button again to return back to regular mode.
Press turtle button and hold for 2 seconds to activate driving function with tiller in its vertical position when
operating in confined areas. The driving function is active only when turtle button is pressed (the speed
is reduced); the release of turtle button will cause immediate stop. The activation of accelerator button in
time gap shorter than two seconds after the turtle button is pressed will not activate the driving function,
the activation cycle has to be repeated from the beginning. Accelerator button should remain in neutral
position till two seconds passed.
Fig.11: Operating direction
