19
33 Check the horn function
•
34 Check the air gap of the electromagnetic brake
•
35 Test the emergency braking
•
36 Test the reverse and regenerative braking
•
37 Test the safety (belly) button function
•
38 Check the steering function
•
39 Check the lifting and lowering function
•
40 Check the tiller proximity switch function
•
General
41 Check if all labels are legible and complete
•
42 Inspect the castors, adjust the height or replace them if worn out.
•
43 Carry out a test run
•
b.
Lubricating points
Lubricate the marked points according to
the maintenance checklist. The required
grease specification is: DIN 51825,
standard grease.
c.
Check and refill hydraulic oil
The required hydraulic fluid- type is:
•
H-LP 46, DIN 51524
•
Viscosity is 41.4 - 47
•
Amount depending on the type 1 L
Waste material like oil, used batteries or other must be probably
disposed and recycled according to the national regulations and if
necessary brought to a recycling company.
The oil level height shall be in the not lifted position min.0.6L to
0.8L.
If necessary add oil at the filling point.
1. Load roller bearing
2. Roller
3. Support castor bearing
4. Steering bearing
5. Gearbox
6. Pump
Fig. 14: Lubricating point
s
Summary of Contents for PT 20I
Page 2: ...1...
Page 4: ...3...
Page 28: ...27 Sign not under on forks O Sign Caution charger H Warning sticker R Warning sticker Q...
