18
Speed Scrub 350 9016424 (09-2017)
OPERATION
FILLING SOLUTION TANK
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
1. Remove the cap from the solution tank.
2. Insert
the
fi
ll hose into the yellow strainer and
ensure the hose is held securely into place in
the strainer.
3. Fill the solution tank with water until level
reaches the 53 L (14 G) mark on the solution
tank indicator.
ec-H2O Scrubbing (Option)
- Fill solution
tank with only cool clean water (less than
70°F/21°C). Do not add conventional
fl
oor
cleaning detergents. An ec-H2O system fault
will occur if cleaning detergents are added.
Conventional Scrubbing
- Fill solution tank
with water (not to exceed 60°C/140°F). Pour
a recommended cleaning detergent into the
solution tank according to mixing instructions
on the container.
ATTENTION:
For Conventional Scrubbing, only
use commercially approved cleaning detergents.
Machine damage due to improper detergent usage
will void the manufacturer’s warranty.
WARNING: Flammable materials can
cause an explosion or
fi
re. Do not use
fl
ammable materials in tank(s).
NOTE: Do not use the ec-H2O system when
there are conventional cleaning detergents in the
solution tank. Drain, rinse, and refi ll the solution
tank with clean cool water before operating the ec-
H2O system. Conventional cleaning detergents will
cause an ec-H2O system fault.
4. Turn off the water supply and remove the
fi
ll
hose from the yellow strainer.
5. Replace the cap on the solution tank.
