65
Speed Scrub 350 9016424 (09-2017)
SUPERVISOR CONTROLS
SUPERVISOR CONTROLS
ATTENTION:
These instructions are intended for
supervisor use only. Remove pages from manual if
necessary.
The supervisor controls feature allows a supervisor
to program the machine’s scrubbing settings for
operator use. The lockout functionality will prevent
the operator from changing or saving the Zone
Settings.
The supervisor controls feature will lower machine
variability for consistent, repeatable cleaning
results, provide machine quality assurance
regardless of user experience, and reduce user
training requirements.
The machine has three supervisor control modes
of operation to choose from:
Unlocked Mode 1:
Operator has full control
of all scrubbing parameters with the ability to
recon
fi
gure the preset zone control buttons. The
Unlocked Mode 1 is the factory default setting.
Lockout Mode 2:
Zone control buttons are preset
and locked by supervisor. Operator has the ability
to recon
fi
gure the preset zone control buttons, but
are not able to save them.
Lockout Mode 3:
Zone control buttons are preset
and locked by supervisor. Operator is restricted
to only use the zone control buttons preset by
supervisor.
ENTERING THE SUPERVISOR CONTROL
MODES
1. Park the machine on a level surface and turn
the key to off ( O ) position.
2. Press and hold the brush pressure button
while turning the key on. Release button
when the far right battery discharge indicator
LED turns on. After releasing button, the
active supervisor control mode will display as
described in step 3.
3. To select or change a supervisor control mode,
press and hold the speci
fi
c zone control button
until the LED blinks three times. For lockout
mode 3, press and hold zone control buttons
1 and 2 at same time. After selection is made,
the LED will turn solid to indicate new mode.
Unlocked mode 1 = Zone control button 1
Lockout mode 2 = Zone control button 2
Lockout mode 3 = Zone control buttons 1 & 2
Unlocked Mode 1
Lockout Mode 2
Lockout Mode 3
4. Press the solution
fl
ow button to con
fi
gure the
zone control button presets for lockout modes
2 or 3.
5. Con
fi
gure the zone control button presets from
list below, then press and hold zone control
button until it blinks three times to save preset.
Repeat process for other two zones. To preset
zone control 3, press zone control buttons 1
and 2 at the same time.
Zone control presets:
- Brush pressure rate
- Solution
fl
ow rate
- Quiet-Mode button on or off
- ec-H2O mode switch on or off
- Severe Environment button on or off
(Hold button for 3 seconds until LED turns on)
- Maximum scrubbing speed setting
