Speed Scrub – Self Test Mode
TO ENTER:
• Press and hold FaST & Vacuum Fan/Squeegee Buttons
• Turn key switch ON, wait 10 seconds
• Release Buttons
• The entire Self Test takes approximately 40 seconds
AFTER THE SELF TEST IS COMPLETE:
• If the One Step LED is lit solid, NO FAULTS were found
• If any LED is blinking, an OPEN FAULT was found –
refer to table below
• If any LED (other than One Step) is lit solid,
a SHORT FAULT was found – refer to table below
Self Test Results
LED (Flashing = OPEN, Solid = SHORT)
System at Fault
One Step LED
No Faults Found
FaST LED
Fast Pump
Vacuum Fan/Squeegee LED
Vacuum-Fan
# 3 (Upper) Brush Pressure LED
Right Brush
# 2 (Middle) Brush Pressure LED
Left Brush
# 1 (Lower) Brush Pressure LED
Head Actuator
# 3 (Upper) Solution Flow LED
Water Valve
# 2 (Middle) Solution Flow LED
Squeegee Actuator
# 1 (Lower) Solution Flow LED
Brake
Recovery Tank Full LED
Horn/Back-up Alarm
28
Summary of Contents for SpeedScrub Rider
