Fasteners and Torque Control (10---90)
Stud or Bolt Size
and Thread
Recommended Torque in
Foot Pounds
7/16---20
75---85
1/2---20
75---85
9/16---18
80---90
5/8---18
140---170
Torque Standard
Wheel Bolt and Nuts
Wheel Bearing Adjustment
1. Tighten the spindle nut to 12 ft lbs while turning the wheel assembly forward by hand to
fully seat the bearings.
2. Back off the nut to the “just loose” position.
3. Hand tighten the spindle nut. Loosen the spindle nut until either hole in the spindle lines
up with a slot in the nut. (Not more than 1/2 flat.)
4. Install the cotter pin. Bend the ends of the cotter pin against the nut, cut off extra length
to ensure ends will not interfere with the dust cap.
40
Summary of Contents for SpeedScrub Rider
