Fasteners and Torque Control (10---90)
Sequence Tightening
On some assemblies, it is advisable to use a crisscross pattern. Always avoid starting in
one spot and tightening one after another in a row. Remember that the object is to tighten
the parts in such a manner that even stress is set up throughout, at the same time allowing
the parts to be drawn together so that their mating surfaces will contact.
5
1
3
4
2
6
1
2
5
3
6
4
1
2
3
4
5
6
Torque in Steps
1. Run each fastener, in proper sequence, up to the recommended torque.
2. Repeat the process of running up each fastener, in proper sequence, up to the
recommended torque.
3. If necessary, repeat step two until all the fasteners are tightened to the recommended
torque.
44
Summary of Contents for SpeedScrub Rider
