3.3.4
If the forks do not elevate while pumping in the
RAISE
position, turn the nut (207) or screw
(111) counter-clockwise until the forks elevate while pumping in the
RAISE
position. Then check
the
LOWER
and
DRIVE
position according to item 3.1, 3.2 and item 3.3.
3.4 Electric wiring for handle
①
find the end of the wire from guard shield;
②
connecting both plug and socket from power
wire and handle wire;
③
coordinating different wire in a clear and tidy
condition, fastening it, so, until now, the work
is done.
3.5 Battery assembling
①
demount the shields of charger and battery in
sequence by screwdriver;
②
moving the battery to close the body of vehicle,
drawing out the end of the connection of the battery;
screw off the plastic cover and the bolt of the battery;
③
connecting anode to B+, cathode to B-, also connecting between anode and cathode of the
battery, cover connection and screw bolt on .
④
Remove the battery slowly, put the battery into box gently, tidy up wires.
⑤
Finally, assembling the shield of battery and charger. Now the work is done.
9
